"Christabella" is an 8.6m traditional carvel planked motor launch, with fibreglass over dynal sheath plywood and has a teak deck. She is powered by a 55hp Perkins 4108 diesel engine, with a conventional shaft drive and a three blade bronze propeller.
The hull has long bilge keels for added stability and for protection should she touch ground on a falling tide whilst at anchor.
The origin of her build is unknown, however it is thought to be in Brisbane around 1937.
A full restoration was undertaken sometime in the early 2000s, by a Gold Coast restaurant owner, who used her to ferry wedding parties to his restaurant.
In around 2008 "Christabella" was sold and moved to Paynesville to cruise the Gippsland Lakes in Victoria.
In May 2013 she was sold again and moved by road transport to South Australia and is currently berthed in beautiful Goolwa, at the mouth of the Murray River.
Famous for the Wooden Boat Festival, Goolwa has access to a large inland waterway with plenty of bays and coves to explore, including the expansive waters of Lake Alexandrina.
LOA: 8.6m - 28ft
Beam: 3m - 9.84ft
Draft: 0.9m - 2.95ft
Engine: Perkins 4108 Diesel Shaft Drive - 55hp
Propeller: 3 Blade Bronze
Keel: Centre Keel providing propeller and rudder protection plus Bilge Keels on each side of the hull for improved stability and grounding protection.
External cover: Canvas - custom made full external cover
Electrical: Complete overhaul of the electrical system with new switch board, new winch motor, new 65 l/t fridge, new Garmin navigational display unit, new horn, installed LED flood lights to the back and front, Carbon Monoxide and smoke detectors, Solar exhaust fan to the bedroom and bathroom, three speed personal fan to the main cabin.
Motor: Perkins 4108 Over hauled motor, replaced injectors, new alternator, new battery, renovated the cooling system including new impellers, renovated the starter motor, renovated the hydraulic steering system, new gaskets to the rocker covers.
Internal: New double flush toilet with a s/steel holding tank for sewer waste, new vinyl clad ceiling panels, replaced all the windows to the main cabin with 10 mm toughened tinted glass, personal access s/steel ladder including timber walk off and on plank, fully lined new curtains.
External: complete painting and varnishing to the whole of the boat including anti foul below water line (carried out 23/10/20 & 14/4/22)
This little motor launch is ideal for her current location, but would also suit the Gippsland Lakes, or perhaps the Hawkesbury River, NSW.
For further details and to arrange inspection, please contact Andy on 0414 782 446 or email to: andy@andydiehmmarine. com
(The information in this advertisement, has been provided by the vessel owner. Please be sure to check with Andy Diehm Marine, to confirm current validity of this information. Andy Diehm Marine will not be held liable "in contract or otherwise" for any loss resulting from the inaccuracy of any information contained in this advertisement. Also, it is important to ensure the safety equipment requirements in your jurisdiction are met prior to the vessel being used)